Circuit Description
The body control module (BCM) checks memory to see if it's in the learn mode. If so, the BCM sets this DTC.
DTC Descriptor
This diagnostic procedure supports the following DTC:
DTC B3031 Security System Controller in Learn Mode
Conditions for Running the DTC
The ignition is ON.
Conditions for Setting the DTC
If the BCM is in the learn mode.
Action Taken When the DTC Sets
| • | The BCM will learn the key code. |
| • | The driver information center (DIC) displays the Theft System Not Programmed message. |
Conditions for Clearing the MIL/DTC
The BCM clears the current status of the DTC when it has learned the first key. The DTC will still be retrieved as current until the ignition switch is cycled. The DTC will become a history DTC at that time.
Test Description
The number below refers to the step number on the diagnostic table.
Step | Action | Yes | No |
|---|---|---|---|
Schematic Reference: Immobilizer Schematics Connector End View Reference: Immobilizer Connector End Views | |||
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | |
|
Important: If a 10-Minute or 30-Minute Relearn Procedure is performed, all keys not learned at that time will be erased and will not be recognized. Perform the Adding Keys procedure on all keys or instruct the customer how to perform the Adding Keys procedure. Refer to Adding Keys . Perform the Programming Theft Deterrent System Components procedure. Refer to Immobilizer System Component Programming . Is the procedure complete? | Go to Step 3 | -- | |
3 |
Does the DTC reset? | Go to Step 2 | System OK |
