Removal Procedure
- Apply masking tape to the door and applique.
- Lower the window to the full down position.
- Remove the front door trim panel. Refer to Front Side Door Trim Panel Replacement .
- Loosen the outside rearview mirror. Refer to Power Mirror Replacement .
- Remove the outer belt sealing strip screw (1).
- Remove the outer belt sealing strip (2) from the door.
Notice: To avoid paint damage, protect the area surrounding the part which you are removing or installing.
Installation Procedure
- Install the outer belt sealing strip (2) to the door.
- Install the outer belt sealing strip screw (1).
- Install the outside rearview mirror. Refer to Power Mirror Replacement .
- Install the front door trim panel. Refer to Front Side Door Trim Panel Replacement .
- Inspect the window for proper operation.
- Remove the masking.
Important: Align the strip properly to the door inner panel for screw installation.
Press the outer belt sealing strip firmly onto the pinch-weld flange.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the screw to 2 N·m (18 lb in).
