For 1990-2009 cars only
Removal Procedure
- Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
- Scribe the strut to the knuckle.
- Remove the bearing/hub assembly. Refer to Rear Wheel Bearing and Hub Replacement .
- Remove the rear wheel spindle rods from the knuckle. Refer to Spindle Rod Replacement .
- Remove the trailing arm (2) from the knuckle (3). Refer to Trailing Arm Replacement .
- Remove the rear strut to knuckle bolts (2) and the nuts (1). Refer to Strut Assembly Replacement .
- Remove the knuckle (5) from the vehicle.
Installation Procedure
- Install the knuckle to the vehicle.
- Hand start the strut to knuckle bolts (2) and nuts (1). Do not tighten the nuts at this time.
- Connect the rear suspension trailing arm (2) to the knuckle (3). Refer to Trailing Arm Replacement .
- Connect the rear wheel spindle rods to the knuckle. Refer to Spindle Rod Replacement .
- Install the bearing/hub assembly. Refer to Rear Wheel Bearing and Hub Replacement .
- Tighten the strut to knuckle bolts (2) and nuts (1).
- Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
- Lower the vehicle.
- Inspect the rear wheel alignment, adjust if necessary. Refer to Wheel Alignment Measurement .
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten bolts to 120 N·m (89 lb ft).
