FRONT PARK LAMP BREAKAGE MODIFY HOUSING/INSTALL BULB

SUBJECT: FRONT PARK LAMP BREAKAGE (MODIFY LAMP HOUSING/INSTALL NEW DESIGN BULB)

VEHICLES AFFECTED: 1988-90 "W" CAR COUPE, 1990-91 SEDAN

Application: 1988-90 Pontiac Grand Prix Coupe and 1990-91 Grand Prix Sedan

Condition: Broken front park lamp bulb.

Cause: Water may enter lamp at drain hole and/or at bulb socket gasket and contact hot bulb.

Correction: Modify the lamp housing and install new design bulb as follows:

Procedure:

----------- 1. Remove the lamp assembly from the lower front fascia by removing two retaining screws. 2. Remove the bulb socket from the lamp housing. 3. Using black RTV sealant such as GM # 12345739 or equivalent, plug the drain hole in the lamp housing. 4. Install new bulb, P/N 9442880 in the lamp assembly.

IMPORTANT: The new design bulb includes a new rubber gasket which should prevent water from entering the lamp at the bulb socket. Using the old style (foam) gasket on the lamp after closing the drain hole may result in a lamp that retains any water that enters at the socket gasket, causing unsightly appearance and future bulb failures.

5. Reinstall the lamp assembly. 6. Repeat procedure on opposite side of vehicle.

Use the most applicable Labour Operation and Time from the Canadian Labour Time Guide.

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.