---------- The condition may be caused by interference of the door upper frame to the auxiliary seal strip along the roof.
------------ This condition may be addressed by using a hammer and a block of wood, bend the auxiliary seal strip mounting flange slightly downward to:
- relieve the interference in affected area but, - not create a gap for wind noise.
It is not necessary to remove the seal strip from the flange for this repair. See Figure 1.
LABOR OPERATION: T-1500 Right Side T-1501 Left Side
LABOR TIME: .3 Hours
General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.