REVISED PROCEDURE FOR GRILLE R AND R OR REPLACE

VEHICLES AFFECTED: 1989 GRAND AM

To ensure proper engagement of the lock tabs of the grille to the headlamp support, during service or replacement, the following procedure should be used. Please mark a reference to this change on Page 2C-4 of your 1989 Grand AM Service Manual.

Procedure:

PROCEDURE OR DISCONNECT

- Lossen energy absorber to bumper bar nuts to allow fascia to lower slightly.

- Gently lift upper grille tabs.

- R and R grille assembly

INSTALL OR CONNECT

Lower grille tabs into slots.

- Grille assembly.

- Position fascia for even 8.0 mm (.315") spacing below grille and tighten energy absorber to bumper bar nuts (30 N.m/22 ft. lbs.).

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.