For 1990-2009 cars only
- Measure the wheel alignment. Refer to Wheel Alignment Measurement .
- Loosen the 2 lock nuts (2, 4) on the rear adjustment link assembly.
- Rotate the center adjuster in order to adjust the rear toe to the specification. Refer to Wheel Alignment Specifications .
- Use a wrench on the hexagonal crimped section of the outer adjustment link (9) in order to hold the position of the ball joint.
- Tighten the 2 lock nuts.
Important: The following components have left-hand threads:
• The inner adjustment link (5) • The inner lock nut (2) • The corresponding end of the adjuster (3)
Increasing the length of the adjustment link assembly will increase the rear wheel toe.
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the 2 lock nuts to 50 N·m
(37 lb ft).
