GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2006 🢒 GTO 🢒 Transmission/Transaxle 🢒 Automatic Transmission - 4L60-E/4L65-E/4L70-E 🢒 Transmission Control Replacement

Removal Procedure
  1. Place the transmission selector lever in the Park position.
  2. Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling in SIR.
  3. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.

    4. Object Number: 1361109 Size: SH
  4. Remove the shift linkage adjusting bolt (1) and the washers from the selector lever (8).
  5. Slide the trunnion (6), sleeve (5) and insulator (4) from the end of the selector linkage.
  6. Position the linkage out of the way.

    7. Object Number: 1361110 Size: SH
  7. Remove the 4 retaining nuts (2) from the selector lever assembly.
  8. Lower the vehicle.
  9. Remove the front console trim plate. Refer to Console Trim Plate Replacement in Instrument Panel, Gages, and Console.

    10. Object Number: 1361111 Size: SH
  10. Slightly raise the selector lever assembly, then disconnect the traction control (T/C) switch connector (1).
  11. Rotate the selector lever indicator lamp (2) counterclockwise, then remove the lamp assembly from the selector lever assembly.
  12. Remove the selector lever assembly from the vehicle.

Installation Procedure
  1. Place the selector lever assembly in the vehicle.

    2. Object Number: 1361111 Size: SH
  2. Slightly raise the selector lever assembly; then connect the T/C switch connector (1).
  3. Rotate the selector lever indicator lamp (2) clockwise to install the lamp assembly in the selector lever assembly.
  4. Raise and suitably support the vehicle.

    5. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 1361110 Size: SH
  5. Install the 4 retaining nuts (2) on the selector lever assembly.

    6. Tighten
    Tighten the retaining nuts to 15 N·m (11 lb ft).


    Object Number: 1361109 Size: SH
  6. Slide the trunnion (6), sleeve (5) and insulator (4) on the end of the selector linkage.
  7. Loosely install the shift linkage adjusting bolt (1) and the washers on the selector lever (8).
  8. Ensure that the transmission and the selector lever assembly are both in the Park position.
  9. Tighten the shift linkage adjusting bolt (1).

    10. Tighten
    Tighten the retaining nuts to 25 N·m (18 lb ft).

  10. lower the vehicle.
  11. Install the front console trim plate. Refer to Console Trim Plate Replacement in Instrument Panel, Gages, and Console.
  12. Enable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling in SIR.