Removal Procedure
- Ensure that the radio is turned OFF.
- Remove the rear quarter upper trim panel. Refer to
Rear Quarter Upper Trim Panel Replacement
in Interior Trim.
- Disconnect the FM antenna/demister connector
(1), and the AM antenna connector (2), from the rear window connectors.
- Disconnect three connectors (3, 4, 5), from the antenna amplifier module
(6).
- Remove two screws (7), securing the antenna amplifier to the vehicle.
- Remove the amplifier retaining screws, then remove the amplifier from
the vehicle.
Installation Procedure
- Position the amplifier in the vehicle.
Notice: Refer to Fastener Notice in the Preface section.
- Install two screws (7), securing the antenna
amplifier to the vehicle.
Tighten
Tighten the antenna amplifier screws to 7 N·m (62 lb in).
- Connect three connectors (5, 4, 3), from the antenna amplifier module
(6).
- Connect the AM antenna connector (2), and the FM antenna/demister connector
(1), to the rear window connectors.
- Install the rear quarter upper trim panel. Refer to
Rear Quarter Upper Trim Panel Replacement
in Interior Trim.
- Check for radio reception.