For 1990-2009 cars only
Removal Procedure
- Remove the front lower fascia grille. Refer to Front Bumper Lower Fascia Grille Replacement in Bumpers.
- From behind the front bumper fascia assembly, disconnect the fog lamp harness (2) from the main harness connector.
- Remove the three nuts (4) securing the front fog lamp assembly (1) to the bumper bar fascia (5).
- Remove the fog lamp assembly (1).
Installation Procedure
- Position the fog lamp assembly (1) to the front bumper bar fascia (5) and route harness (2) through access hole (3).
- Ensure that the fog lamp assembly (1) is correctly orientated with the beam adjustment screw located to the top.
- Ensure that the lamp is located on the fascia datum pins
- Install the three front fog lamp nuts (4) to the fog lamp (1).
- Check and adjust the front fog lamp aim as necessary. Refer to Fog Lamp Aiming .
- Install the front bumper fascia lower grille. Refer to Front Bumper Lower Fascia Grille Replacement in Bumpers.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the nuts to 2 N·m (18 lb in).
