Removal Procedure
- Remove the rear seat cushion. Refer to
Rear Seat Cushion Replacement
in Seats.
- Remove the rear seat back. Refer to
Rear Seat Back Replacement
in Seats.
- Remove the door sill plate. Refer to
Door Sill Plate Replacement
.
- Remove the rear quarter trim panel. Refer to
Rear Quarter Trim Panel Replacement
.
- Remove the upper center pillar cap (1)
from the upper attachment of the upper center pillar upper trim (2).
- Remove 3 screws (3) securing the upper center pillar trim.
- Pull the upper edge of the upper center pillar away from the headliner
to disengage the upper center pillar retaining clip (4).
Important: When removing the upper center pillar trim panel, ensure not to damage the locating
pin below the upper attaching screw.
- Feed the seat belt and anchor plate through the upper center pillar trim panel,
then remove the trim panel.
- If required, remove the seat belt adjuster trim (5), by gently
spreading the outer edges of the hinge pillar trim panel.
Installation Procedure
- If removed, install the seat belt adjuster
trim (5) to the hinge pillar trim panel.
- Feed the seat belt and anchor plate through the upper center pillar trim
panel, then install the trim panel.
- Push the upper edge of the upper center pillar trim panel to the headliner
to engage the center upper pillar trim panel retaining clip (4).
Notice: Refer to Fastener Notice in the Preface section.
- Install 3 screws (3) securing the upper center pillar trim panel.
Tighten
Tighten the 3 upper center pillar trim panel retaining screws to 2 N·m
(18 lb in).
- Install the upper center pillar trim panel cap (1) to the upper
attachment of the upper center pillar trim panel (2).
- Install the rear quarter trim panel. Refer to
Rear Quarter Trim Panel Replacement
.
- Install the door sill plate. Refer to
Door Sill Plate Replacement
.
- Remove the rear seat back. Refer to
Rear Seat Back Replacement
in Seats.
- Remove the rear seat cushion. Refer to
Rear Seat Cushion Replacement
in Seats.