GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2007 🢒 G6 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Radio Replacement

Removal Procedure
  1. Remove the instrument panel (I/P) center trim panel. Refer to Instrument Panel Center Trim Panel Replacement .
  2. Remove the HVAC control module. Refer to HVAC Control Module Replacement .

    3. Object Number: 1207653 Size: SH
  3. Remove the radio screws.
  4. Remove the radio.
  5. Remove the radio wire harness connector.
  6. Remove the antenna cable at the radio.

Installation Procedure
  1. Install the antenna cable at the radio.
  2. Install the radio wire harness connector.

    3. Object Number: 1207653 Size: SH

    Important: Verify that the locator pin on the back of the radio is firmly seated in the I/P structure extension.

  3. Install the radio.

    4. Notice: Refer to Fastener Notice in the Preface section.

  4. Install the radio screws.

    5. Tighten
    Tighten the screws to 2.5 N·m (22 lb in).

  5. Install the HVAC control module. Refer to HVAC Control Module Replacement .
  6. Install the I/P center trim panel. Refer to Instrument Panel Center Trim Panel Replacement .
  7. Program the radio after replacement. Refer to Control Module References .