Tools Required

J 43631 Ball Joint Separator

1. Raise the vehicle on a hoist. Refer to Lifting and Jacking the Vehicle .
2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
3. Remove the brake rotor. Refer to Rear Brake Rotor Replacement .



4. Using the J 43631 , release the wheel stud from the bearing hub and discard the stud .

1. Install a NEW stud into the bearing/hub assembly. Add enough washers (3) in order to draw the stud into the hub.
2. Install and tighten a wheel nut (1) until the head of the wheel stud is fully seated against the back of the bearing/hub flange.
3. Remove the wheel nut (1) and the washers (3).
4. Install the brake rotor. Refer to Rear Brake Rotor Replacement .
5. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
6. Lower the vehicle.