Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

Preliminary Procedure

Use a J 25070 or equivalent in a circular motion to warm the quarter panel bodyside molding prior to removal. Carefully clean the body panel thoroughly prior to bonding the molding to the body side quarter panel.

1

Quarter Panel Center Molding Assembly

Tip

1. Upon installation of the new molding, align the pin on the backside of the molding to the round hole first then to the oval hole.
2. Ensure full adhesion to the body using the palm of the hand with a dry towel working down the molding.

2

Adhesive Tape Protective Liner

Tip
Remove the protective liner from the backside of the molding in order to secure the molding to the door.