Scan Tool Parameter | Data Display | Units Displayed | Typical Data Value |
|---|---|---|---|
Operating Conditions: Ignition in the ON position, folding top in the fully closed position, vehicle in park, trunk closed, and luggage barrier in place. | |||
Battery Voltage | Inputs/Outputs/Data | Volts | 12 Volts |
Folding Top Bell Crank Sw. | Inputs | Over Center/Not Over Center | Over Center |
Folding Top Downstack Receiver Sw. | Inputs | In Position/Not in Position | Not in Position |
Folding Top Header Dowel Pin | Inputs | In Position/Not in Position | In Position |
Folding Top Header Latch Cyl. | Inputs | Latched/Unlatched | Latched |
Folding Top Header Latched | Inputs | Yes/No | Yes |
Full Cycle Counter | Data | Counts | Varies |
Hall Sensor Feed Status | Outputs | OK/No Output | OK |
Inputs Correct to Start | Data | Yes/No | Yes |
LF RCL Latched Switch | Inputs | Active/Inactive | Active |
LF RCL Unlatched Switch | Inputs | Active/Inactive | Inactive |
Logic Battery | Inputs/Outputs/Data | Volts | 12 Volts |
Luggage Barrier In Place | Inputs | Yes/No | Yes |
Motor Command | Inputs/Outputs | Amps | 0 amps |
Outputs Correct to Start | Data | Yes/No | Yes |
Pump Motor Command | Outputs | A Direction/B Direction/Idle/Error | Idle |
Pump Over Temperature Sensor | Data | Normal/Overtemp | Normal |
RCL Cylinder Extended | Inputs | Yes/No | No |
RCL Front Sw. Ready to Latch | Inputs | In Position/Not in Position | In Position |
RCL Release Switch | Inputs | Latched/Unlatched/Transition/Invalid | Unlatched |
Rear Compartment Lid Ajar | Data | Yes/No | No |
RF RCL Latched Switch | Inputs | Active/Inactive | Active |
RF RCL Unlatched Switch | Inputs | Active/Inactive | Inactive |
Too Cold For Top Operation | Data | Yes/No | No |
Top Control Switch | Inputs | Opening/Closing/Idle/Invalid | Idle |
Valve 1 Command | Outputs | On/Off | Off |
Valve 2 Command | Outputs | On/Off | Off |
Vehicle In Park | Data | Yes/No | Yes |
Window Motor Output | Outputs | Up/Down/Idle | Idle |
