Notice: Cap the fittings and plug the holes when servicing the fuel system in order to prevent dirt and other contaminants from entering the open pipes and passages.

Important: Always maintain cleanliness when servicing fuel system components.

1. Drain the fuel tank. Refer to Fuel Tank Draining .
2. Remove the fuel fill pipe bolt from the fuel fill pocket.
3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .



4. Remove the fuel fill pipe bolt from the underbody.



5. Loosen the fuel fill pipe hose clamp (1) at the fuel tank.
6. Disconnect the evaporative emission (EVAP) canister vent solenoid tube quick connect fitting (2). Refer to Plastic Collar Quick Connect Fitting Service .
7. Disconnect the vapor recirculation line quick connect fitting (3). Refer to Plastic Collar Quick Connect Fitting Service .
8. Disconnect and remove the fuel fill pipe hose assembly.

Notice: Refer to Fastener Notice in the Preface section.




1. Install and connect the fuel fill pipe hose assembly.
2. Tighten the fuel fill pipe hose clamp (1) at the fuel tank.

Tighten
Tighten the clamp to 4 N·m (35 lb in).

3. Connect the EVAP canister vent solenoid tube quick connect fitting (2). Refer to Plastic Collar Quick Connect Fitting Service .
4. Connect the vapor recirculation line quick connect fitting (3). Refer to Plastic Collar Quick Connect Fitting Service .



5. Install the fuel fill pipe bolt to the underbody.

Tighten
Tighten the bolt to 10 N·m (89 lb in).




6. Lower the vehicle.
7. Install the fuel fill pipe bolt to the fuel fill pocket.

Tighten
Tighten the bolt to 1.5 N·m (13 lb in).