ARMREST BIN LID MOUNTING PLATE BREAKAGE (INSTALL PLATE)

SUBJECT: ARMREST BIN LID MOUNTING PLATE BREAKAGE (INSTALL NEW MOUNTING PLATE)

MODELS: 1992-94 PONTIAC BONNEVILLE

CONDITION:

SOME OWNERS MAY COMMENT ON BREAKAGE OF THE ARMREST BIN LID MOUNTING PLATE.

CAUSE:

BREAKAGE IS DUE TO THE ARMREST BIN LID BEING EXTENDED TOO FAR WHILE OPEN.

CORRECTION:

THE MOUNTING PLATE FOR THE ARMREST BIN LID HAS BEEN REDESIGNED. DO NOT REPLACE BOTH THE BIN LID AND THE BIN LID MOUNTING PLATE. THE CORRECT PROCEDURE IS TO REPLACE THE BIN LID MOUNTING PLATE ONLY.

1. REMOVE THE ARMREST BIN LID. REFER TO SECTION 8C IN THE SERVICE MANUAL.

2. REMOVE BIN LID MOUNTING PLATE FASTENERS AND MOUNTING PLATE.

3. INSTALL NEW BIN LID MOUNTING PLATE, P/N 25536564, AND FASTENERS.

4. INSTALL ARMREST BIN LID. REFER TO SECTION 8C IN THE SERVICE MANUAL.

PARTS ARE CURRENTLY AVAILABLE FROM GMSPO.

WARRANTY INFORMATION:

FOR VEHICLES REPAIRED UNDER WARRANTY, USE:

LABOR OPERATION NUMBER: C2740 USE PUBLISHED LABOR OPERATION TIME.

FIGURES: 1

GENERAL MOTORS BULLETINS ARE INTENDED FOR USE BY PROFESSIONAL TECHNICIANS, NOT A "DO-IT-YOURSELFER". THEY ARE WRITTEN TO INFORM THOSE TECHNICIANS OF CONDITIONS THAT MAY OCCUR ON SOME VEHICLES, OR TO PROVIDE INFORMATION THAT COULD ASSIST IN THE PROPER SERVICE OF A VEHICLE. PROPERLY TRAINED TECHNICIANS HAVE THE EQUIPMENT, TOOLS, SAFETY INSTRUCTIONS AND KNOW-HOW TO DO A JOB PROPERLY AND SAFELY. IF A CONDITION IS DESCRIBED, DO NOT ASSUME THAT THE BULLETIN APPLIES TO YOUR VEHICLE, OR THAT YOUR VEHICLE WILL HAVE THAT CONDITION. SEE A GENERAL MOTORS DEALER SERVICING YOUR BRAND OF GENERAL MOTORS VEHICLE FOR INFORMATION ON WHETHER YOUR VEHICLE MAY BENEFIT FROM THE INFORMATION.

COPYRIGHT 1994 GENERAL MOTORS CORPORATION. ALL RIGHTS RESERVED.