1991-93 6000, BONNEVILLE, GRAND PRIX AND TRANS SPORT MODELS
TRANSAXLE APPLICATIONS: HYDRA-MATIC 4T60 (RPO ME9) ---------------------- HYDRA-MATIC 4T60-E (RPO M13)
TRANSAXLE MODELS: ALL ---------------- CONDITION: --------- Some vehicles equipped with a HYDRA-MATIC 4T60 (RPO ME9) or 4T60-E (RPO M13) transaxle built on or before June 23, 1993 (Julian Date 174), may exhibit a transaxle bearing whine that is audible in 1st, 2nd, and 3rd gear. The whine is most audible on the "driver's" side of the vehicle while in 2nd gear during a light throttle acceleration.
CAUSE: (Figure 1) ----- The Bearing Assembly, 4th Channel Plate Hub/Channel Plate" (503/ 431) may have been improperly installed causing the needle bearings to leave indentation marks on the bearing race.
---------- Replace the "Bearing Assembly, 4th Channel Plate Hub/Channel Plate" (503/431) located on the "Channel Plate Assembly" (404/401).
Part number for the "Bearing Assembly, 4th Channel Plate Hub/ Channel Plate" is the same for the 4T60 and 4T60-E transaxle.
PART NUMBER DESCRIPTION ----------- ----------- 8656393 Bearing Assembly, 4th Channel Plate Hub/Channel Plate
Parts are currently available from GMSPO.
General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.