GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Oldsmobile 🢒 2001 🢒 Intrigue 🢒 Body and Accessories 🢒 Lighting Systems 🢒 DTC B2603

Circuit Description

The body control module (BCM) illuminates the LF turn signal lamp during daytime running lamps operation in the day mode. The BCM applies steady power to the LF turn signal lamp which illuminates the LF turn lamp in a non flashing mode.

Conditions for Running the DTC

The BCM must be commanding the LF turn signal lamp ON.

Conditions for Setting the DTC
    • The BCM detects a short to battery in the supply voltage circuit of the LF turn signal lamp or in the LF signal circuit of the turn signal switch.
    • The condition above must be present for more than 20 seconds.

Action Taken When the DTC Sets

The BCM stores DTC B2603 in memory.

Conditions for Clearing the DTC
    • A current DTC B2603 will clear if the BCM no longer detects a short to battery in the supply voltage circuit of the LF turn signal lamp.
    • A history DTC B2603 will clear after 100 consecutive ignition cycles if the condition for the condition is no longer present.
    • The BCM receives the clear code command from the scan tool.

Diagnostic Aids
    • If the DTC B2603 is a history DTC, the fault may be intermittent. Refer to Testing for Intermittent Conditions and Poor Connections in Wiring Systems.
    • The following conditions may cause an intermittent condition to occur:
       - An intermittent short to battery in the supply voltage circuit of the LF turn signal lamp or in the LF signal circuit of the turn signal switch.
       - The BCM is intermittently shorted to battery.

Test Description

The numbers below refer to the step numbers on the diagnostic table.

  1. Tests for voltage at the turn signal lamp.

    2.

  2. Tests the supply voltage circuit of the turn signal for a short to voltage.

Step

Action

Yes

No

Schematic Reference: Exterior Lights Schematics

1

Did you perform the Lighting System Diagnostic System Check?

Go to Step 2

Go to Diagnostic System Check - Lighting Systems

2
  1. Install a scan tool.
  2. Turn ON the ignition, with the engine OFF.
  3. With a scan tool, command the LF turn signal lamp control ON and OFF.

Does the LF turn signal lamp turn ON and OFF with each command?

Go to Diagnostic Aids

Go to Step 3

3

  1. Turn OFF the ignition.
  2. Disconnect the LF turn signal lamp.
  3. Turn ON the ignition, with the engine OFF.
  4. Probe the LF turn signal lamp voltage supply circuit with a test lamp that is connected to ground.

Does the test lamp illuminate?

Go to Step 4

Go to Step 5

4

Repair the LF turn signal lamp voltage supply circuit for a short to battery postive voltage. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you complete the repair?

Go to Step 6

--

5

Important: Perform the set up procedure for the BCM. Refer to Body Control Module (BCM) Programming/RPO Configuration in Body Control System.

Replace the BCM. Refer to Body Control Module Replacement in Body Control System.

Did you complete the replacement?

Go to Step 6

--

6
  1. Use the scan tool in order to clear the DTCs .
  2. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text.

Does the DTC set again?

Go to Step 2

System OK