GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Oldsmobile 🢒 2001 🢒 Intrigue 🢒 HVAC 🢒 HVAC Systems - Manual 🢒 Temperature Valve Actuator Replacement - Right Side

Removal Procedure
  1. Remove the right side instrument panel insulator. Refer to Instrument Panel Insulator Replacement in Instrument Panel, Gauges and Console.
  2. Remove the instrument panel compartment. Refer to Instrument Panel Compartment Replacement in Instrument Panel, Gauges and Console.

    3. Object Number: 295333 Size: SH
  3. Disconnect the electrical connector from the right air temperature actuator.

    4. Object Number: 295335 Size: SH
  4. Remove the screws retaining the right air temperature actuator.
  5. Remove the electric actuator.

Installation Procedure

    Object Number: 295335 Size: SH
  1. Position the air temperature actuator, then align the slots in the electric actuator driver to the flats on the shaft.
  2. Align the locating hole to the alignment pin on the HVAC module case.
  3. Slide the actuator driver on to the shaft. The actuator driver should seat completely on to the shaft and the mounting holes should be flush with the mounting bolts on the HVAC case.

    4. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  4. Install the screws to the right air temperature actuator.

    5. Tighten
    Tighten the right air temperature actuator screws to 1.5 N·m (13 lb in).


    Object Number: 295333 Size: SH
  5. Connect the electrical connector to the right air temperature actuator.
  6. Install the instrument panel compartment. Refer to Instrument Panel Compartment Replacement in Instrument Panel, Gauges and Console.
  7. Install the right side instrument panel insulator. Refer to Instrument Panel Insulator Replacement in Instrument Panel, Gauges and Console.
  8. Re-calibrate the actuator. Refer to Actuator Recalibration .