Tools Required

J 29142 Oil Filter Wrench

1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Position an oil drain pan under the engine oil filter cap and the oil drain plug.



3. Loosen the oil pan drain plug.



4. Remove the oil pan drain plug.
5. Clean and inspect the oil pan drain plug, repair or replace if necessary.
6. Clean and inspect the oil pan drain plug sealing surface on the oil pan, repair or replace oil pan if necessary.



7. Use the J 29142 in order to loosen the engine oil filter cap.



8. Remove the oil filter cartridge and engine oil filter cap .
9. Clean and inspect the engine oil filter cap, repair or replace if necessary.
10. Clean and inspect the engine oil filter cap sealing surface on the oil pan, repair or replace oil pan if necessary.

1. Install the new oil filter cartridge and engine oil filter cap. Refer to Maintenance Items in Maintenance and Lubrication.




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Use the J 29142 in order to tighten the engine oil filter cap.

Tighten
Tighten the engine oil filter cap to 25 N·m (18 lb ft).




3. Install the oil pan drain plug.



4. Tighten the oil pan drain plug.

Tighten
Tighten the oil pan drain plug to 20 N·m (15 lb ft).

5. Remove the oil drain pan from under the vehicle.
6. Lower the vehicle.
7. Fill the engine with new engine oil. Refer to Approximate Fluid Capacities and Fluid and Lubricant Recommendations in Maintenance and Lubrication
8. Inspect for leaks.