Notice: Do not use solvent of any type when cleaning the gasket surfaces on the intake manifold and the throttle body assembly, as damage to the gasket surfaces and throttle body assembly may result.

1. Turn OFF the ignition.



2. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement in Engine Mechanical.



3. Drain the radiator coolant. Refer to Cooling System Draining and Filling in Engine Cooling.
4. Remove the air cleaner intake duct (3). Refer to Air Cleaner Inlet Duct Replacement .



5. Disconnect the idle air control (IAC) valve sensor electrical connector (4).
6. Disconnect the throttle position (TP) sensor electrical connector (3).



7. Disconnect the cruise control cable from the throttle body lever. Refer to Cruise Control Cable Replacement in Cruise Control .



8. Disconnect the accelerator control cable from the throttle body lever. Refer to Cruise Control Cable Replacement in Cruise Control.



9. Disconnect the fuel pressure regulator vacuum hose (1).



10. Disconnect the positive crankcase ventilation (PCV) valve hose (1).
11. Disconnect the throttle body vacuum port hose (2).



12. Disconnect the throttle body coolant hoses.
13. Remove the accelerator controls cable bracket, leaving the accelerator and cruse cables connected. Refer to Accelerator Control Cable Bracket Replacement .
14. Remove the upper nut holding the throttle body to the intake manifold (1).
15. Remove the throttle body assembly (3).
16. Clean the gasket surface on the intake manifold (1) and the throttle body assembly.

Important: The throttle should operate freely without binding between full closed and wide open throttle (WOT).

1. Install a new gasket (2), and new studs if necessary.
2. Install the throttle body assembly (3).
3. Finger start the top nut.
4. Connect the throttle body coolant hoses.
5. Position the accelerator controls bracket (4).

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

6. Finger start the accelerator controls bracket retaining nuts and bolt.

Tighten

•	Tighten the three throttle body retaining nuts to 10 N·m (89 lb in).

•	Tighten the accelerator bracket retaining bolt to 10 N·m (89 lb in).




7. Connect the throttle body vacuum port hose (2).
8. Connect the PCV valve hose (1).



9. Connect the fuel pressure regulator vacuum hose (1).



10. Connect the accelerator controls cable to the throttle body lever. Refer to Accelerator Control Cable Replacement .



11. Connect the cruise control cable to the throttle body lever. Refer to Cruise Control Cable Replacement in Cruise Control.



12. Connect the IAC valve sensor electrical connector (4).
13. Install the TP sensor electrical connector (3).



14. Install the air intake duct (3). Refer to Air Cleaner Inlet Duct Replacement .
15. Refill the radiator to replace the lost coolant. Refer to Cooling System Draining and Filling in Engine Cooling.



16. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement in Engine Mechanical.