GM Service Manual Online
For 1990-2009 cars only

Due to a worldwide shortage of ethylene glycol, some coolant manufacturers have started to mix other types of glycol into their coolant formulations. Propylene glycol is the most common ingredient. A hydrometer will not always provide a correct measurement of freeze protection when anything other than ethylene glycol and water is being tested. The degree of inaccuracy will vary depending on the proportion other glycols present in the coolant.

All GM vehicles are produced with coolant you can accurately measure with a hydrometer. However, when the type and quality of the coolant being measured is unknown, such as a vehicle that has accumulated mileage, use a refractometer.

Use coolant testers J 26568 or J 23688 to check the antifreeze protection of the coolant. The markings of the refractometer must be correct. Unless J 23688 or J 26568 has a provision for temperature correction, test the temperature at which J 26568 or J 23688 is calibrated. If the coolant is warmer or cooler, the reading may be incorrect. Follow the manufacturer's directions on using J 26568 or J 23688 .

Testing Procedure

Tools Required

    • J 23688 Coolant Tester (Fahrenheit Scale)
    • J 26568 Coolant Tester (Centigrade Scale)

    Important: 

       • Both the J 23688 and the J 26568 automatically compensate for temperature.
       • Before each use, swing back the plastic cover at the slanted end of the coolant tester, exposing the measuring window and the bottom of the plastic cover.
       • Wipe the measuring window dry with a tissue or a clean, soft cloth.
       • Close the plastic cover.

  1. Release the tip of the pump from the housing of the J 23688 or the J 26568 .
  2. Do not remove the clear plastic pump from the J 23688 or the J 26568 .
  3. Caution: As long as there is pressure in the cooling system, the temperature can be considerably higher than the boiling temperature of the solution in the radiator without causing the solution to boil. Removal of the pressure cap while the engine is hot and pressure is high will cause the solution to boil instantaneously -- possibly with explosive force -- spewing the solution over the engine, fenders and the person removing the cap.

  4. Remove the surge tank cap.

  5. Object Number: 13709  Size: SH
  6. Insert the tip of the pump into the surge tank. The tip of the pump must be below the level of the coolant.
  7. Press the bulb. Release the pump bulb in order to obtain a sample of the coolant.
  8. Bend the tube around the J 23688 or the J 26568 . Insert the tip of the pump into the cover plate opening.
  9. Press the pump bulb. Allow a few drops to fall onto the measuring surface. Do not open the plastic cover when taking readings because any water evaporation will change the reading.

  10. Object Number: 13713  Size: SH
  11. Point the coolant concentration tester toward any light source. Look into the eyepiece.
  12. • The coolant protection reading is at the point where the dividing line between light and dark crosses the scale. Antifreeze protection is the scale on the right.
    • The temperature scale is reversed from a standard thermometer scale. Below zero readings are on the upper half of the scale.

    Object Number: 13712  Size: SH
  13. If the readings are not clear, properly clean and dry the measuring surface. Conduct a new test. Make sure there is enough fluid on the measuring surface.