The front inside door handle bezel has an electrical connector for the power door lock system.

1. Hold the inside door handle open in order to gain access to the inside door handle bezel close out plate.
2. Use a small, flat-bladed tool in order to remove the inside door handle bezel close out plate from the bottom access slot.
3. Remove the screw which secures the inside door handle bezel to the door.
4. Remove the inside door handle bezel from the door trim panel.



5. Remove the inside door handle bezel electrical door lock connector (front door only).
6. Remove the inside door handle bezel from the vehicle.

1. Connect the electrical door lock connector to the inside door handle bezel (front door only).
2. Align the inside door handle bezel to the door trim panel.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.




3. Install the screw which secures the inside door handle bezel to the door.

Tighten
Tighten the screw to 2 N·m (18 lb in).

4. Align the close-out plate to the inside door handle bezel.
5. Apply pressure to the close-out plate until fully seated.