GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Oldsmobile 🢒 2000 🢒 Intrigue 🢒 Body and Accessories 🢒 Body Front End 🢒 Hood Primary and Secondary Latch Replacement

Removal Procedure

    Object Number: 363798 Size: SH
  1. Open the hood.
  2. Mark the hood latch to the center support bracket with a grease pencil.
  3. Remove the bolts from the hood latch.
  4. Remove the hood latch from the hood latch support.

    5. Object Number: 456709 Size: SH

    Important: Do not crimp the hood release cable.

  5. Remove the hood release cable from the hood latch by squeezing the cable retainer.
  6. Remove the hood latch from the vehicle.

Installation Procedure

    Object Number: 456709 Size: SH
  1. Install the hood release cable to the hood latch.

    2. Object Number: 363798 Size: SH
  2. Align the hood latch to the marks on the center support bracket.

    3. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the hood latch to center support bracket bolts.

    4. Tighten
    Tighten the bolts to 25 N·m (18 lb ft).

  4. Close the hood.