Transmitter Programming Procedure (Method 1-No Tools Required)
In the event that a transmitter is lost, program the old and the new
transmitters into the memory of the remote control door lock receiver. Up
to 4 transmitters may be programmed.
Important: Once the keyless entry receiver enters the programming/diagnostic mode,
the programming of the first transmitter erases all previous transmitter programming
information. You must then program all of the transmitters.
Program only 1 vehicle remote control door lock receiver at a
time. If you program multiple receivers simultaneously, the same transmitter
may possibly be programmed to more than 1 remote control door
lock receiver.
- Sit in the driver's seat.
- Remove the ignition key from the ignition lock cylinder.
- Close all the vehicle doors.
- Press and hold unlock on the door lock switch.
- While holding the door lock switch in the unlock position, insert
and remove the ignition key twice. Do not rotate the ignition lock cylinder.
- Insert the ignition key a third time leaving the key in the ignition
lock cylinder. The ignition must remain in the LOCK position for the rest
of the procedure.
- Release the door lock switch. You will hear three chimes. This
chime feedback indicates that transmitter programming is active.
- Press and hold the lock and unlock buttons at the same time on
the keyless entry transmitter for 12 seconds. You will hear three chimes.
This chime feedback indicates that the transmitter has been programmed successfully.
- Repeat step 8 for the rest of the transmitters (for a total of
4 transmitters).
- Exit this procedure by removing the ignition key from the ignition
lock cylinder.
Transmitter Programming Procedure (Method 2 Scan Tool Required)
In the event that a transmitter is lost, program the old and the new
transmitters into the memory of the remote control door lock receiver. Up
to 4 transmitters may be programmed.
Important: Once the keyless entry receiver enters the programming/diagnostic mode,
the programming of the first transmitter erases all previous transmitter programming
information. You must then program all of the transmitters.
Program only 1 vehicle remote control door lock receiver at a
time. If you program multiple receivers simultaneously, the same transmitter
may possibly be programmed to more than 1 remote control door
lock receiver.
The following procedure describes how to program the remote control
door lock transmitters to the remote control door lock receiver using the
Tech 2®.
Perform the following steps:
- Connect the scan tool to the following components:
• | An applicable power source |
• | The vehicle data link connector (DLC) |
- Turn the ignition ON.
- At the application menu screen, select F0 (body control
module).
- At the body control module screen, select F2 (special functions).
- At the special functions menu screen, select F3 (program
key fobs).
- Follow the directions on the scan tool display in order to program
the transmitters.
- Press EXIT repeatedly until you view the application menu screen.
- Disconnect the scan tool from the following components:
• | The accessory power port |
- Validate that all the transmitters that were programmed operate
properly. Refer to
Keyless Entry System Operation
.