TAIL LAMP REFLECTOR STRIP WARPAGE SUBJECT (INSTALL NEW REFLECTOR STRIP)
The reflector strip on the lower bezel assembly of the vehicles involved may warp and distort when exposed to high ambient temperatures. A redesigned reflector strip has been released for production and service. Vehicles built after vehicle number LM783982 will have the new bezels.
To correct this condition, it will be necessary to replace the old bezel reflector assembly with the redesigned part as follows:
1. Remove the tail lamp assembly from the vehicle as described in the appropriate Cutlass Calais Service Manual.
2. Remove the reflector - bezel assembly from the tail lamp assembly by releasing the 11 lock tabs along the lower edge of the tail lamp assembly.
3. Install the new reflector strip by aligning the 11 lock tabs and snapping the strip in place.
4. Install the tail lamp assembly as described in the appropriate Cutlass Calais Service Manual.
5. Check for proper operation of all rear lights.
Part Name: Lower bezel assembly (reflector strip)
Part Number: Base Model 1-Series/442
(New) 16515120 16515123 REPLACES (Old) 16510048 16512319
Parts are currently available from GMSPO.
Labor Operation Number: B8688
Labor Time: See current Labor Time Guide
Trouble Code: 92
General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.