Loose or Broken Rear Compartment Opening Molding (Install New Molding Assembly)
| Subject: | Loose or Broken Rear Compartment Opening Molding (Install New Molding Assembly) |
| Models: | 1997-2002 Chevrolet Malibu |
| 1997-1999 Oldsmobile Cutlass |
| 1999-2002 Oldsmobile Alero |
| 1999-2002 Pontiac Grand Am |
This bulletin is being revised to add a model. Please discard Corporate Bulletin Number 02-08-66-005 (Section--Body and Accessories)
Condition
Some owners may comment that the molding along the rear (trunk) compartment opening at the striker is loose or broken.
Cause
This condition may be caused because the tabs that the molding retainers attach to on the underside of the molding may have broken off.
Correction
Install a new molding assembly. The new molding assemblies listed below come pre-assembled with the retainers and screws already attached. It is NOT necessary to disassemble or remove the retainers from the molding for installation.
Procedure
- Open the rear compartment (trunk) lid.
- Remove the old molding by carefully pulling it straight up.
- Remove any old retaining clips that may be remaining in the body sheet metal openings.
- With the retainers attached to the underside, position the new molding assembly to the body and press down to lock the retainers in the sheet metal openings.
- Close the rear compartment lid.
Parts Information
Part Number | Description |
|---|---|
22685720 | Plate, Rear Compartment Sill Trim 1999-2002 Alero |
226685721 | Plate, Rear Compartment Sill Trim 1999-2002 Grand Am |
22685722 | Plate, Rear Compartment Sill Trim 1997-99 Cutlass 1997-2002 Malibu |
Parts are currently available from GMSPO.
Warranty Information
For vehicles repaired under warranty, use:
Labor Operation | Description | Labor Time |
|---|---|---|
C4660 | Trim, Rear Compartment End Panel -- Replace | 0.2 hr |
