For 1990-2009 cars only
Removal Procedure
- Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Remove the spare tire.
- Disconnect rear exhaust hangers and lower exhaust system, if necessary.
- Support the rear axle.
- Remove the spring shackle to frame mounting nut and bolt.
- Remove the spring shackle to leaf spring mounting nut and bolt.
- Remove the spring shackle from the vehicle.
Installation Procedure
- Install the spring shackle to the vehicle.
- Install the spring shackle to leaf spring mounting bolt and nut.
- Install the spring shackle to frame mounting bolt and nut.
- Raise the axle support so that there is a distance of 164 mm to 176 mm (6.46 in to 6.94 in) between the axle tube and the metal surface of the bumper bracket (1).
- Tighten the spring shackle mounting nuts.
- Remove rear axle support.
- Raise exhaust system and connect rear exhaust hangers, if necessary.
- Install the spare tire.
- Lower the vehicle.
Do not tighten the nut.
Do not tighten the nut.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the spring shackle mounting nuts to 122 N·m
(89 lb ft).
