Oil Pan Replacement RWD

1. Remove the engine. Refer to Engine Replacement .
2. Remove the oil pan drain plug and drain the engine oil into a suitable container.
3. Remove the oil pan. Refer to Oil Pan Removal .
4. Clean and inspect all parts. Refer to Oil Pan Cleaning and Inspection .

1. Install the oil pan. Refer to Oil Pan Installation .
2. Install the engine. Refer to Engine Replacement .
3. Fill the engine with oil. Refer to Engine Oil and Oil Filter Replacement .

Oil Pan Replacement 4WD

1. Disconnect the battery negative cable. Refer to Battery Replacement in Engine Electrical.
2. Remove the oil level indicator.
3. Remove the front differential assembly. Refer to Differential Carrier Assembly Replacement in Front Drive Axle.
4. Remove the starter. Refer to Starter Motor Replacement in Engine Electrical.
5. Remove the transmission cover.
6. Remove the oil pan drain plug and drain the engine oil into a suitable container.
7. Remove the remote oil filter pipe adapter. Refer to Oil Filter Adapter Replacement .



8. Remove the bolt holding the remote oil filter inlet and outlet hose clip to the oil pan.



9. Remove the stud holding the bracket for the starter wire harness and if equipped, the transmission oil cooler pipes.



10. Remove the access plugs for the oil pan rear nuts.



11. Remove the transmission to oil pan bolts (automatic transmission shown).
12. Remove the oil pan from the engine. Refer to Oil Pan Removal .
13. Clean all sealing surfaces and the oil pan. Refer to Oil Pan Clean and Inspect .

Notice: Any time the transmission and the engine oil pan are off of the engine at the same time, install the transmission before the oil pan. This is to allow for the proper oil pan alignment. Failure to achieve the correct oil pan alignment can result in transmission failure.

1. Install the oil pan. Refer to Oil Pan Installation .

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the transmission to oil pan bolts.

Tighten
Tighten the transmission to the oil pan bolts to 47 N·m (35 lb ft).




3. Install the access plugs for the oil pan rear nuts.



4. Install the stud holding the bracket for the starter wire harness and if equipped, the transmission oil cooler pipes.

Tighten
Tighten the bracket stud to 9 N·m (80 lb in).

5. Install the remote oil filter pipe adapter. Refer to Oil Filter Adapter Replacement .



6. Install the bolt holding the oil filter inlet and outlet hose clip to the oil pan.

Tighten
Tighten the hose clip bolt to 10 N·m (88 lb in).




7. Install the transmission cover and bolts.

Tighten
Tighten the transmission cover bolts to 12 N·m (106 lb in).

8. Install the starter motor. Refer to Starter Motor Replacement in Engine Electrical.
9. Install the front differential assembly. Refer to Differential Carrier Assembly Replacement in Front Drive Axle.
10. Install the oil level indicator.
11. Fill the engine with engine oil. Refer to Engine Oil and Oil Filter Replacement .
12. Connect the battery negative cable. Refer to Battery Replacement in Engine Electrical.