For 1990-2009 cars only
Removal Procedure
- Disable the SRS system. Refer to Disabling the SRS in SRS.
- Remove the upper and lower steering column trim covers. Refer to Steering Column Trim Cover Replacement - On Vehicle .
- Turn the ignition lock cylinder to the start position.
- Using an awl, insert the tip into the ignition lock cylinder access hole (1).
- Push down and hold the ignition lock cylinder retaining pin.
- Release the ignition lock cylinder to the run position.
- Remove the ignition lock cylinder by pulling the ignition lock cylinder away from the steering column (2).
Caution: This vehicle is equipped with a Supplemental Restraint System (SRS).
Failure to follow the correct procedure could cause the following conditions:
• Air bag deployment • Personal injury
In order to avoid the above conditions, observe the following guidelines:
• Unnecessary SRS system repairs • Refer to SRS Component Views in order to determine if you are
performing service on or near the SRS components or the SRS wiring. • If you are performing service on or near the SRS components or
the SRS wiring, disable the SRS system. Refer to Disabling the SRS System
in SRS.
Installation Procedure
- Install the ignition lock cylinder to the steering column (2) by performing the following procedure:
- Install the upper and lower steering column trim covers. Refer to Steering Column Trim Cover Replacement - On Vehicle .
- Enable the SRS system. Refer to Enabling the SRS in SRS.
- Perform the Passlock learn procedure. Refer to PASSLOCK Reprogramming Auto Learn in Theft Deterrent.
| 1.1. | Align the positioning locking tab slot on the lock module assembly to the positioning tab on the ignition lock cylinder. |
| 1.2. | Push the lock cylinder in until the locking tab locks in the lock module assembly. |
