GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Isuzu 🢒 2000 🢒 S/T Isuzu - 2WD 🢒 Transmission/Transaxle 🢒 Manual Transmission - NV 3500 🢒 Transmission Housing Oil Seal Replacement

Tools Required

    • J 23907 Slide Hammer
    • J 36825 Output Shaft Oil Seal Remover
    • J 36502-2A Output Shaft Seal Protector/Installer
    • J 36502 Extension Housing Seal Installer

Removal Procedure
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the rear propeller shaft. Refer to Rear Propeller Shaft Replacement or Two-Piece Propeller Shaft Replacement in Propeller Shaft.

    3. Object Number: 4781 Size: SH
  3. UsingJ 36825 andJ 23907 , pry the seal out of the extension housing.

Installation Procedure

    Object Number: 4757 Size: SH
  1. PositionJ 36502-2A over the output shaft.

    2. Object Number: 4758 Size: SH
  2. UsingJ 36502 install the rear output shaft seal.

    3. Object Number: 4757 Size: SH
  3. RemoveJ 36502-2A from the output shaft.

    4. Object Number: 7909 Size: SH
  4. Fill the space between the seal lips with grease.
  5. Install the rear propeller shaft. Refer to Rear Propeller Shaft Replacement or Two-Piece Propeller Shaft Replacement in Propeller Shaft.
  6. Check the transmission oil level. Refer to Fluid Replacement .
  7. Lower the vehicle.