GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Isuzu 🢒 2000 🢒 S/T Isuzu - 2WD 🢒 Driveline/Axle 🢒 Front Drive Axle 🢒 Axle Lubricant Change

Removal Procedure
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the front differential carrier shield. Refer to Shield Replacement .

    3. Object Number: 598203 Size: SH
  3. Remove the fill plug and the washer.

    4. Object Number: 598199 Size: SH
  4. Remove the drain plug.

Installation Procedure

    Object Number: 598199 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  1. Install the drain plug.

    2. Tighten
    Tighten the drain plug to 33 N·m (24 lb ft).

  2. Fill the differential with lubricant. Refer to Lubrication Specifications .
  3. Install the washer and the fill plug.

    4. Tighten
    Tighten the fill plug to 33 N·m (24 lb ft).


    Object Number: 598203 Size: SH
  4. Install the front differential carrier shield. Refer to Shield Replacement .