GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Isuzu 🢒 2000 🢒 S/T Isuzu - 2WD 🢒 Engine 🢒 Engine Electrical 🢒 Underhood Fuse Block Replacement

Removal Procedure

    Caution: Before servicing any electrical component, the ignition and start switch must be in the OFF or LOCK position and all electrical loads must be OFF, unless instructed otherwise in these procedures. If a tool or equipment could easily come in contact with a live exposed electrical terminal, also disconnect the negative battery cable. Failure to follow these precautions may cause personal injury and/or damage to the vehicle or its components.

  1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .

    2. Object Number: 182736 Size: SH
  2. Remove the battery positive cable cover.

    3. Object Number: 197383 Size: SH
  3. Remove the battery positive cable bolt.
  4. Remove the battery positive cable.

    5. Object Number: 182740 Size: SH
  5. Remove the bolts that attach the underhood fuse block to the underhood fuse block support bracket.

    6. Object Number: 197403 Size: SH
  6. Loosen the bolts that secure the electrical connectors to the bottom of the underhood fuse block.

    7. Object Number: 197410 Size: SH
  7. Disconnect the electrical connectors from the underhood fuse block.
  8. Remove the underhood fuse block from the vehicle.

Installation Procedure

    Object Number: 197410 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  1. Connect the electrical connectors to the underhood fuse block.

    2. Tighten
    Tighten the electrical connector to the underhood fuse block bolts to 7 N·m (62 lb in).


    Object Number: 182740 Size: SH
  2. Install the bolts that attach the underhood fuse block to the underhood fuse block support bracket.

    3. Tighten
    Tighten the underhood fuse block to the underhood fuse block support bracket bolts to 7 N·m (62 lb in).


    Object Number: 197383 Size: SH
  3. Attach the battery positive cable with bolt to the underhood fuse block.

    4. Tighten
    Tighten the battery positive cable to the underhood fuse block bolt to 10 N·m (89 lb in).


    Object Number: 182736 Size: SH
  4. Replace the battery positive cable cover.
  5. Connect battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .