For 1990-2009 cars only
Removal Procedure
- Disconnect the negative battery cable.
- Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- For a 2WD vehicle, skip steps 6 and 7.
- Remove the AIR shield mounting bolts.
- Remove the AIR shield.
- Remove the retaining bolts from the steering linkage shield.
- Remove the steering linkage shield.
- Disconnect the solenoid vacuum hoses.
- Disconnect the solenoid electrical connector.
- Remove the retaining screw from the bracket.
- Remove the solenoid.
Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.
For a 4WD vehicle, skip steps 4 and 5.
Installation Procedure
- Align the new soleniod bracket hole with hole in the AIR pump bracket.
- Install the retainer screw (1).
- Connect the solenoid electrical connector.
- Connect the solenoid vacuum hoses.
- For a 2WD vehicle, skip steps 8 and 9.
- Align the AIR shield.
- Install the AIR shield mounting bolts.
- Align the steering linkage shield.
- Install the linkage shield mounting bolts.
- Lower the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Connect the negative battery cable.
For a 4WD vehicle, skip steps 6 and 7.
Tighten
Tighten the bolts to 33 N·m (24 lb ft).
Tighten
Tighten the bolts to 33 N·m (24 lb ft).
