Removal Procedure
- Disconnect the negative battery cable.
- Remove the electrical connector bolt from EBCM.
- Disconnect the electrical connector from EBCM.
- Remove the 4 bolts (2) and 4 washers (3) and remove the EBCM from the bracket.
Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.
Installation Procedure
- Install EBCM (1) to bracket.
- Install the 4 EBCM mounting bolts (2) and washers (3).
- Connect the EBCM electrical connector.
- Install the EBCM electrical connector bolt.
- Connect the negative battery cable.
- Perform the diagnostic system check. Refer to Diagnostic System Check - Air ABS .
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the EBCM mounting bolts to 8 N·m (71 lb in).
Tighten
Tighten the EBCM electrical connector bolt to 2 N·m (18 lb in).
