GM Service Manual Online
For 1990-2009 cars only
Makes
🢒
Isuzu
🢒
2008
🢒
Ascender - 2WD
🢒
Diagnostic Navigation
🢒
Vehicle Diagnostic Information
🢒 Stop Lamp Switch Replacement
Removal Procedure
Remove the left sound insulator. Refer to
Instrument Panel Insulator Panel Replacement - Left Side
.
Remove the pushrod retainer (3) from the brake pedal pin (4).
Remove the stop lamp switch (1) and the pushrod (2) from the brake pedal pin (4).
Disconnect the stop lamp switch (1) electrical connector.
Remove the stop lamp switch from the vehicle.
Installation Procedure
Install the electrical connector to the stop lamp switch (1).
Position the stop lamp switch (1) on the pushrod (2) and install the assembly on the brake pedal pin.
Install the pushrod retainer (3) to the brake pedal pin (4). The retainer will snap into place.
Install the left sound insulator. Refer to
Instrument Panel Insulator Panel Replacement - Left Side
.