Caution: Replace the passenger presence system as a complete assembly to prevent possible injury to the occupant. All the components in the service kit are assembled and calibrated as a unit. Using only some of the components in the service kit will cause the passenger presence system to operate improperly.

Notice: Refer to Fastener Notice in the Preface section.

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

Preliminary Procedure

1. Remove the front bucket seat. Refer to Front Seat Replacement - Bucket .
2. Remove the seat cushion trim cover and pad. Refer to Seat Cushion Trim Cover and Pad Replacement .
3. Re-zero the inflatable restraint passenger presence system whenever the seat cushion or any component of the passenger presence system is removed. Refer to Passenger Presence System Programming and Setup .
4. Program the inflatable restraint passenger presence system after replacement. Refer to Control Module References .

1

Retainer, Inflatable Restraint Passenger Presence System (Qty: 2)

2

Sensor, Inflatable Restraint Passenger Presence System

Tip
Disconnect the electrical connector.

3

Screw, Inflatable Restraint Passenger Presence System Module (Qty: 2)

Tighten
8 N·m (71 lb in)

4

Module, Inflatable Restraint Passenger Presence System

Tip
Disconnect the electrical connector.