Notice: Refer to Fastener Notice in the Preface section.

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

Preliminary Procedure

1. Remove the HVAC module assembly. Refer to HVAC Module Assembly Replacement
2. Remove the air inlet assembly. Refer to Air Inlet Assembly Replacement .
3. Disconnect the recirculation actuator electrical connector.

1

Screw, Recirculation Housing (Qty: 4)

Tighten
1.5 N·m (14 lb in)

2

Housing, Recirculation

3

Screw, Recirculation Actuator (Qty: 3)

Tighten
1.5 N·m (13 lb in)

4

Actuator, Recirculation

Important: Do no adjust any controls on the HVAC control assembly while the HVAC control assembly and actuators are calibrating. If interrupted improper HVAC performance will result.