GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 HUMMER 🢒 2006 🢒 H2 🢒 Vehicle Control Systems 🢒 Vehicle DTC Information 🢒 Instrument Cluster Replacement

Removal Procedure

Important: The ignition switch must be in the OFF position when removing the instrument panel cluster.


    Object Number: 815927 Size: SH
  1. Remove the I/P cluster trim plate from the instrument panel. Refer to Instrument Cluster Trim Panel Replacement .
  2. Remove the screws from the I/P cluster to instrument panel.

    3. Object Number: 816330 Size: SH
  3. Remove the I/P cluster from the instrument panel.

    4. Object Number: 816329 Size: SH
  4. Disconnect the I/P cluster electrical connections.

Installation Procedure

    Object Number: 816329 Size: SH
  1. Connect the electrical connections to the cluster.
  2. Position the I/P cluster to the instrument panel.

    3. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 816330 Size: SH
  3. Install the screws to the instrument panel cluster.

    4. Tighten
    Tighten the screws to 2 N·m (18 lb in).


    Object Number: 815927 Size: SH
  4. Install the instrument cluster trim plate. Refer to Instrument Cluster Trim Panel Replacement .

    5. When the I/P cluster is replaced the new I/P cluster will need to be programmed. Refer to Instrument Cluster Programming and Setup in Vehicle Control Systems.