GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 1350838  Size: SH
  1. Remove the front door trim panel. Refer to Front Side Door Trim Panel Replacement .
  2. Remove the front door water deflector. Refer to Front Side Door Water Deflector Replacement .
  3. Important: The outside handles have adjustable outside handle lock rods. This allows for adjustment of the amount of travel needed in order to operate the outside handle.

    When servicing a vehicle with adjustable outside handle lock rods, remove all free play between the outside handle and the lock. Also, do not operate the outside handle before these connections are made.

  4. Open the outside handle rod to lock clip located on the door lock.
  5. The outside handle rods should be loose from the lock.

  6. Remove the lock cylinder rod from the outside door handle. Refer to Door Lock Cylinder Replacement .

  7. Object Number: 1363738  Size: SH

    Important: Do not attempt repairs in order to correct lock discrepancies. Replace the lock.

  8. Remove the screws from door lock.
  9. Unclip the electrical harness from the door frame.
  10. Remove the lock cylinder rod.
  11. Remove the door lock and cable through the access hole in the door inner panel.
  12. Disconnect the electrical connector from the lock.
  13. Remove the lock and cable from the door.

Installation Procedure

  1. Install the lock and cable to the door.
  2. Connect the electrical connector to the lock.
  3. Install the lock and cable through the access hole in the door inner panel.
  4. Install the lock cylinder rod.
  5. Clip the electrical harness to the door frame.
  6. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 1363738  Size: SH
  7. Install the screws to the door lock.
  8. Tighten
    Tighten the screws to 10 N·m (89 lb in).

  9. Install the lock cylinder rod to the outside door handle. Refer to Door Lock Cylinder Replacement .

  10. Object Number: 1350838  Size: SH
  11. Install the outside handle rod into the clip.
  12. Close the clip over the outside handle rod.
  13. Install the inside door handle. Refer to Front Side Door Inside Handle Replacement .
  14. Inspect the door for proper operation.
  15. Install the front door water deflector. Refer to Front Side Door Water Deflector Replacement .
  16. Install the front door trim panel. Refer to Front Side Door Trim Panel Replacement .