- Lubricate the camshaft journals and the bearings with clean engine oil.
- Install 3 M8 - 1.25 x 100 mm (M8 - 1.25 x 4.0 in) bolts into the camshaft front bolt holes.
- Using the bolts as a handle, carefully install the camshaft into the engine block.
- Remove the 3 bolts from the front of the camshaft.
- Install the camshaft retainer and the bolts.
- Inspect the camshaft sensor O-ring seal. If the O-ring seal is not cut or damaged, it may be used again.
- Lubricate the O-ring seal with clean engine oil.
- Install the camshaft position sensor and bolt.
Important: If camshaft replacement is required, the valve lifters must also be replaced.
Notice: All camshaft journals are the same diameter, so care must be used in removing or installing the camshaft to avoid damage to the camshaft bearings.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Important:
• Install the retainer plate with the sealing gasket facing the engine
block. • The gasket surface on the engine block should be clean and free of dirt
or debris.
Tighten
Tighten the camshaft retainer bolts to 25 N·m
(18 lb ft).
Tighten
Tighten the camshaft position sensor bolt to 25 N·m
(18 lb ft).
