Body Side Lower Rear Molding Replacement Model

1. Remove the rear corner extension molding retainers.
2. Remove the rear corner extension molding.
3. Remove the cladding screws.
4. Remove the cladding retainers.
5. Remove the cladding from the body. Refer to Adhesive Retained Cladding Replacement .

1. Install the cladding to the body. Refer to Adhesive Retained Cladding Replacement .

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the cladding screws.

Tighten
Tighten the cladding screws to 2 N·m (18 lb in).

3. Install the cladding retainers.
4. Install the rear corner extension molding.



5. Install the rear corner extension molding retainers.