Removal Procedure
Caution: In order to reduce the risk of fire and personal injury observe the
following items:
• | Replace all nylon fuel pipes that are nicked, scratched or damaged
during installation, do not attempt to repair the sections of the nylon fuel
pipes |
• | Do not hammer directly on the fuel harness body clips when installing
new fuel pipes. Damage to the nylon pipes may result in a fuel leak. |
• | Always cover nylon vapor pipes with a wet towel before using a
torch near them. Also, never expose the vehicle to temperatures higher than
115°C (239°F) for more than one hour, or more than 90°C (194°F)
for any extended period. |
• | Apply a few drops of clean engine oil to the male pipe ends before
connecting fuel pipe fittings. This will ensure proper reconnection and prevent
a possible fuel leak. (During normal operation, the O-rings located in the
female connector will swell and may prevent proper reconnection if not lubricated.) |
- Relieve the fuel system pressure. Refer to
Fuel Pressure Relief
.
- Open the hood .
- Remove the left side splash shield. Refer to
Wheelhouse Splash Shield Replacement
in Body Front End.
Important:
• | Clean all the fuel pipe connections and the surrounding areas before
disconnecting the pipes in order to avoid possible contamination of the fuel system. |
• | Cap all fuel pipes to avoid possible contamination of the fuel system. |
- Disconnect the fuel feed line from the fuel filter
pipe. Refer to
Metal Collar Quick Connect Fitting Service
.
- Unclip the fuel filter pipe retaining clip.
- Remove the fuel filter pipe from the fuel filter head .
Installation Procedure
- Install the fuel feed pipe to the fuel filter head.
Refer to
Metal Collar Quick Connect Fitting Service
.
- Connect the fuel feed pipe the retainer .
- Connect the fuel feed line to the fuel feed pipe .
- Inspect for fuel leaks .