Removal Procedure
- Disconnect the electrical connector.
- Using a plastic flat bladed tool, release the double sided tape that retains
the light assembly to the vehicle.
Installation Procedure
- Install the light assembly into the vehicle with
double sided tape.
Important: In order to insure a good replacement of new adhesive or of old adhesive, verify
that the surface meets the following conditions:
| • | The temperature of the surface is approximately 24-41°C (80-105°F). |
| • | The surface is clean. |
| • | The surface is free of wax or of oily film. |
- Connect the electrical connector.
