Throttle Body Cleaning. GMC Truck Savana 2001

For 1990-2009 cars only

Makes 🢒 GMC_Truck 🢒 2001 🢒 Savana 🢒 Engine 🢒 Engine Controls - 5.0L and 5.7L 🢒 Throttle Body Cleaning

Cleaning Procedure

Notice: Do not subject a throttle body assembly which contains the following components to an immersion cleaner or a strong solvent:

•	Throttle position (TP) sensor

•	Idle air control (IAC) valve

•	Sealed throttle shaft bearings

The cleaners will damage the electric components or sensors.

The cleaners will damage some of these components that contain seals or O-rings.

Solvents can wash away or break down the grease used on non-serviceable throttle shaft bearings.

Never use a wire brush or scraper to clean the throttle body. A wire brush or sharp tools may damage the throttle body components.

Do not use a cleaner that contains methyl ethyl ketone. This extremely strong solvent may damage components and is not necessary for this type of cleaning.

Clean the throttle body bore and throttle valve plate on the vehicle using a clean shop towel with GM Top Engine Cleaner, P/N 1052626 or AC-Delco Carburetor Tune-Up Conditioner P/N X66P, or equivalent. Remove and disassemble the throttle body for cleaning if the deposits are excessive. Refer to Throttle Body Assembly Replacement , Idle Air Control Valve Replacement and Throttle Position Sensor Replacement . After disassembly, clean the throttle body using a parts cleaning brush. DO NOT immerse the throttle body in any cleaning solvent.