Step
| Action
| Value(s)
| Yes
| No
|
1
| Was the Wiper/Washer System Check
performed?
| --
| Go to
Step 2
| Go to
Wiper/Washer System Check
|
2
|
- Disconnect connector C200 at the steering column.
- Connect a J 39200
between connector C200, cavity E4 of CKT 93 (YEL)
pigtail and cavity E3 of CKT 92 (PPL) pigtail.
- Place the windshield washer/wiper switch in the HIGH position.
Is continuity present?
| --
| Go to
Step 4
| Go to
Step 3
|
3
|
- Repair the open in CKT 92 (PPL) pigtail in the steering
column.
- If there is no open in the circuit, replace the multifunction
switch. Refer to Multifunction, Turn Signal and Hazard Switch Replacement - On Vehicle
in Steering
Wheel and Column-Standard or Multifunction, Turn Signal and Hazard Switch Replacement - On Vehicle
in Steering Wheel and Column-Tilt.
Do the wipers still not run at high speed?
| --
| Go to
Step 4
| Go to
Wiper/Washer System Check
|
4
|
- Reconnect connector C200.
- Disconnect the connector at the windshield washer motor.
- Connect a unpowered test lamp between windshield wiper motor connector
cavity C in CKT 92 (PPL) and ground.
- Turn the ignition switch to the RUN position.
- Place the windshield wiper switch in the HIGH position.
Did the test lamp light?
| --
| Go to
Step 6
| Go to
Step 5
|
5
| Repair the open in CKT 92 (PPL) between connector C200
pin E3 and the windshield wiper motor connector cavity C.
Do the wipers still not run at high speed?
| --
| Go to
Step 6
| Go to
Wiper/Washer System Check
|
6
| Replace the windshield wiper motor.
Do the wipers still not run at high speed?
| --
| --
| Go to
Wiper/Washer System Check
|
