GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 1999 🢒 Savana 🢒 Engine 🢒 Engine Controls - 5.0L and 5.7L 🢒 Engine Controls Schematic Icons

Icon

Icon Definition


Object Number: 19384 Size: GT

Refer to

Notice: Electrostatic discharge (ESD) can damage many solid-state electrical components. ESD susceptible components may or may not be labeled with the ESD symbol. Handle all electrical components carefully. Use the following precautions in order to avoid ESD damage:

   • Touch a metal ground point in order to remove your body's static charge before servicing any electronic component; especially after sliding across the vehicle seat.
   • Do not touch exposed terminals. Terminals may connect to circuits susceptible the ESD damage.
   • Do not allow tools to contact exposed terminals when servicing connectors.
   • Do not remove components from their protective packaging until required to do so.
   • Avoid the following actions unless required by the diagnostic procedure:
      - Jumpering or grounding of the components or connectors.
      - Connecting test equipment probes to components or connectors. Connect the ground lead first when using test probes.
   • Ground the protective packaging of any component before opening. Do not rest solid-state components on metal workbenches, or on top of TVs, radios, or other electrical devices.

in Caution and Notices.


Object Number: 19385 Size: GT

Refer to

Notice: The OBD II symbol is used on the circuit diagrams in order to alert the technician that the circuit is essential for proper OBD II emission control circuit operation. Any circuit which fails and causes the malfunction indicator lamp (MIL) to turn ON, or causes emissions-related component damage, is identified as an OBD II circuit.

in Caution and Notices.


Object Number: 296880 Size: GT

Important: These wires will be twisted a minimum of ten (10) turns per foot (31 cm) and the diameter shall not exceed 0.6 cm as measured anywhere between the connectors. The wires will not be twisted for a distance of 10 cm (3.9 in) maximum from each connector. Whenever repairing these wires, follow the above specified tolerances in order to ensure proper circuit operation.