Removal Procedure
- Remove the pins (1) that hold the weather-strip
to the upper door.
- Remove the weather-strip (3) from the upper door.
- Clean the surface of the door with approved cleaning solvent.
Installation Procedure
- Remove peel-off liner from saturated foam.
- Spray 85% alcohol 15% water mixture per GM 9981293 on saturated
foam patch.
- Locate the part by lining up the two pins (1) on the top of the
weather-strip with the holes in the door sheet metal.
- Insert the "pocket" over the door flange and push
down the pins until they are fully seated and there are no gaps between the
door and the weather-strip (3).
- Insert the pin that is located on the "pocket" into
the door sheet metal until it is fully seated and there is no gap between
the door and the weather-strip.
- Complete the installation by tucking the bottom inner edge of
the weather-strip (3) into the top door flange.