Notice: When servicing a vehicle that requires replacement of the master cylinder, the reservoir, or the tubing, you must replace the entire master cylinder assembly. Replacement of individual components cannot be performed. A complete pre-filled, pre-bled master cylinder must be installed.

Tools Required

J 36221 Quick Connect Coupling Removal Tool

1. Disconnect the pushrod from the clutch pedal.



2. Remove the hydraulic tube from the concentric slave cylinder quick connect coupling. UseJ 36221 to depress the white plastic sleeve on the quick connect coupling to separate the clutch line from the concentric slave cylinder.



3. Remove the plastic clip and the clutch line from the frame.



4. Rotate the master cylinder 45 degrees clockwise. Remove the master cylinder from the cowl panel.

1. Install the master cylinder to the cowl panel by holding it at a 45 degree angle and rotating it counterclockwise. Be sure not to over rotate the master cylinder or damage will occur.



2. Install the hydraulic tube to the concentric slave cylinder quick connect coupling.



3. Install the tube clips to the frame.
4. Install the pushrod to the clutch pedal. Check the reservoir for fluid. If more fluid is required, add DOT 3 brake fluid GM P/N 1052535 or the equivalent.
5. Connect the pushrod to the clutch pedal.